 Pond
PhosGuard™ is a filtration product that promotes
algae control for ponds. It is a porous adsorbent
that removes phosphates, silicates, and other nutrients
that support algae growth. It does not harm aquatic
plants. It does not release anything into the water,
but instead works by starving algae rather than poisoning
it. A 2 Liter size treats over 600 gallons.
Sizes: 1 L, 2 L, 4 L, 20 L |
| |
DIRECTIONS: Use Pond PhosGuard™ in
the chemical module of your pond filter. If
a chemical module is lacking, place in your
pond filter so as to maximize the amount of
water passing through it. The beads are sufficiently
large that a filter bag should not be required
for most filters. Check the specifications for
your filter. Each liter (approximately a quart)
of Pond PhosGuard™ will treat about 100
to 300 gallons for 1 to 3 months, depending
on the biological load of the pond. It works
better at alkaline or neutral pH. Avoid using
phosphate based buffers or fertilizers that
contain phosphate or nitrate. Caution: May generate
heat on initial contact with water. Pre-wet
by slowly adding to a double volume of water
(e.g. pre-wet 1 L of product with 2 L of water)
Caution!
May generate heat on initial contact with water.
Pre-wet by adding to a double volume of freshwater
(e.g. 250 mL of product in 500 mL water), followed
by a rinse. |
| |
|
|
